MS8106 – PID and ON/OFF controller


  • P, PI, PID, 2- and 3 state control modes 
  • Function Autotuning
  • Shockless switching between automatic and manual mode
  • Non-volatile memory
  • Communication (option) – RS485, MODBUS RTU Protocol




MS8106 v1_43_2018-05-23_BG
MS8106 v1_43_2018-05-23_EN
MS8106 v1_43_2018-05-23_RU


The PID controller MS8106 of MICROSYST is designed for measuring and control of different process parameters. It can realize P, PI or PID control (program selectable), and there is a possibility for limitation of the integral component. There are also 2 and 3state control modes. The outputs are controlled by pulse width modulation (PWM), there is a possibility for setting of different times for forming of “positive” (K1) and “negative” (K2) output.
All data are stored in non-volatile memory, including the current state of the controller, i.e. after restoring of the power supply, it enters the same control mode, in which it has been before its fault (the integral component is reset in this case, so till its second accumulation there will be an interference in the controlled parameter for PI or PID controller).
There is a shockless switching between automatic and manual mode, direct supervision of the process variable (Pv), the set-point (SP) and the output (Out). By the function Autotuning you can easy tune the PID parameters